Metabo BKH 400 Operation Instructions Manual page 18

8.2 Mitre fence
A - The 0° (90°) end
point of the mitre fence
is fitted with a stop
screw. Through scre-
wing the stop screw in
or out, the end point
can be given a fine
adjust-ment.
8.3 Central position of the saw blade
Underneath the table there are adjustment screws on
both sides of the chip case.
After the clamping screws of the chip case have been
loosened, the saw blade can be slid sideways by turning
the adjustment screws in or out.
°
8.4 90 Setting of the saw blade
The 90° position of the saw blade relative to its table can
be corrected through sliding the chip thousing. In order
to do that you have to loosen the connection screws
between the chip case and the cross-tie first.
B It is advisible to check the adjustment with
a test cut.
C The arc scale is adjusted after having loose-
ned the three clamping screws.