Table of Contents
Advertisement
DMX-512 CONTROLLER CONNECTION
Connect the provided XLR cable to the female XLR output of your controller and the
other side to the male XLR input of this fixture. The diagram below illustrates a typical
DMX-512 connection when the fixture is in the 5 Channel Mode. You can chain
multiple panels together through serial linking. The cable that should be used is two
conductor, shielded DMX cable with XLR input and output connectors. Always be
sure daisy chain your in and out data connections, never split or "Y" your DMX
connections unless you are using an approved DMX splitter such as Elation's Opto
Branch 4™, Opto Branch 8™, or DMX-Branch/4™.
Address 1
Be sure to follow the above figure when making your own cables. Do
not use the ground lug on the XLR connector. Do not connect the
cable's shield conductor to the ground lug or allow the shield
conductor to come in contact with the XLR outer casing. Grounding
the shield could cause a short circuit and erratic behavior.
Address 6
w w w . e l a t i o n l i g h t i n g . c o m
15
WW PROFILE™ User Manual Version 1
Address 11
Advertisement
Table of Contents
