5. ASSEMBLY
Your water pump requires some assembly and is ready for use after it has been properly filled with the
recommended oil and fuel. If you have any problems with the assembly of your water pump, please call
the water pump help line at 01646 687 880. If calling for assistance, please have the model and serial
number available.
5.1. Connecting the suction hose to the pump.
5.1.1. Slide hose clamp (A) over end of hose (B). Slide suction hose onto hose barb (C). Tighten
hose clamp securely to the hose.
5.2. Attaching the suction hose to the strainer basket.
5.2.1. Slide hose clamp over the hose. Attach open end of the suction hose to strainer hose barb.
Tighten hose clamp securely.
5.3. Insert connect discharge hose (Optional).
5.3.1. If desired, use a commercially available hose. DO NOT use a hose with an inside diameter
smaller than the pump's discharge port size.
5.3.2. Slide barb cuff over hose barb. Insert rubber seal into end of barb cuff as shown earlier.
5.3.3. Screw hose barb assembly onto pump in clockwise rotation until hose barb assembly is
tightened securely.
Hose connections are supplied.
Hoses ARE NOT supplied as standard with pump.
PAGE 12