Remote Control - Electrolux EASC12F2MBKLW Instruction Manual

33 electrolux remote control

Remote control

Remote control operation
1. Operating Mode: AUTO, COOL, DRY,
HEAT(Cooling only model without),
and FAN.
2. Timer Setting Function in 24 hours.
3. Indoor Setting Temperature Range :
17。C~30。C.
4. Full function of LCD (Liquid Crystal
Display).
REMOTE CONTROLLER SPECIFICATIONS
Rated voltage
Lowest of voltage of CPU emiting signal
Transmission distance
Environment
* (with 3 V, it reaches 11 m)
1. The air conditioner will not operate if curtains, doors or other materials block
the signals from the remote controller to the indoor unit.
2. Prevent any liquid from falling into the remote controller. Do not expose the
remote controller to direct sunlight or heat. If the infrared signal receiver on
the indoor unit is exposed to direct sunlight, the air conditioner may not
function properly. Use curtains to prevent the sunlight from falling on the
receiver.
3. If other electrical appliances react to the remote controller. Either move these
appliances or consult your authorized assistance.
Remote control battery
To use the remote control, it is necessary to install two (R03/Ir03x2) alkaline
AAA batteries.
MODE SHORTCUT
FAN
SWING TEMP
SPEED
TIMER TIMER
SWING
OFF
ON
RESET LOCK
3 V
2,0 V
8 m*
-5ºC ~ 60ºC
When should the batteries be
replaced
1. Replace the batteries when there
is no receiving beep from the
indoor unit or if the transmission
indicator on the remote controller
fails to light.
2. The remote controller is powed by
two dry batteries(R03/LR03X2)
housed in the rear part and
protected by a cover.
3. Remove the cover by pressing
and sliding off.
4. Remove the old batteries and
insert the new batteries,placing
the(+) and (-) ends correctly.
5. Reattach the cover by sliding it
back into position.
Remote control instructions
Use the remote controller within a
distance of 8 meters from the
appliance, pointing it towards the
receiver. Reception is confirmed by a
beep.
remote control electrolux 34
1. When the batteries are removed,
the remote controller erases all
programming.
2. After inserting new batteries, the
remote controller must be
reprogrammed.
3. Do not mix old and new batteries or
batteries of different types.
4. Do not leave the batteries in the
remote controller if they are not
going to be used for 2 or 3 months.
5. Do not dispose batteries as
unsorted municipal waste.
Collection of such waste separately
for special treatment is necessary.