Operation Test; Preparing The Device For Operation - Electrolux EASC12F2MBKLW Instruction Manual

29 electrolux operation test

Operation test

Perform test operation after completing gas leak check at the flare nut
connections and electrical safety check.
1. Connect the power, press the
ON/OFF button on the remote
controller to turn the unit on.
2. Use the MODE button to select
COOL, HEAT, AUTO and FAN to
check if all the functions works
well.
3. When the ambient temperature is
too low(lower than 17ºC), the unit
cannot be controlled by the remote
controller to run at cooling mode,
manual operation can be taken.
Manual operation is used only when
the remote controller is disable or
maintenance necessary.
Auto/Cool
or
Manual control button
Manual control
button
Auto
Cool
preparing the device for operation electrolux 30

Preparing the device for operation

1. Contact a specialist to install the device.
2. Guarantee that the unit is appropriately fastened and complies with all of
the aforementioned safety norms.
3. Before operating the air conditioner, ensure that the air filter is installed
correctly.
4. If the unit has been out of use for a long period of time, it is recommended
that the air filter be cleaned before use. During continuous use, clean the air
filter every two weeks.
5. This air conditioner was designed for use under the following conditions:
Temperature/Mode Cooling mode
≥17°C (62°F)
Room temperature
0°C ~ 50°C
(32°F~122°F)
Outdoor
temperature
-15°C ~ 50°C*
(5°F~122°F)
* For models with low temperature system
Optimum performance will be achieved within these operating temperatures.If air
conditioner is used outside of the above conditions, certain safety protection
features might come into operation and cause the unit to function abnormally.
Room relative humidity less than 80%. If the air conditioner operates in excess of
this figure, the surface of the air conditioner may attract condensation. Please
sets the vertical air flow louver to its maximum angle (vertically to the floor), and
set HIGH fan mode.
For the unit adopts an Electric Heater, when the outside ambient temperature
is below 0°C(32°F), we strongly recommend you to keep the machine plugged in
order to guarantee it running smoothly.
Heating mode Drying mode
≤30°C (86°F)
> 10°C (50°F)
-15°C ~ 30°C
0°C ~ 50°C
(5°F~86°F)
(32°F~122°F)