Indoor Unit Installation Location; Installing The Indoor Unit - Mitsubishi Electric PEH-2.5EAK Installation Manual

. Indoor unit installation location
D
Fig. -1
11
100
600
300
Fig. -
3. Installing the indoor unit
Fig. 3-1
W
H
Models W D
PE(H)-2.5, 3 785 690
PE(H)-4 1055 690
PE-5, 6/PEH-5 1255 690
PEH-6 1415 690
200 200
21
11
A B
530
900
2.1. Outline dimensions (Fig. 2-1)
• Select a location so that air can be blown into all corners of the room.
• Avoid locations exposed to outside air.
• Select a location free of obstructions to the airflow in and out of the unit.
• Avoid locations exposed to steam or oil vapour.
• Avoid locations where combustible gas may leak, settle or be generated.
• Avoid installation near machines emitting high-frequency waves (high-frequency
welders, etc.)
• Avoid locations where the airflow is directed at a fire alarm sensor. (Hot air could
trigger the alarm during the heating operation.)
• Avoid places where acidic solutions are frequently handled.
(mm)
• Avoid places where sulphur-based or other sprays are frequently used.
H
428
Warning:
428
The unit must be securely installed on a structure that can sustain its weight.
428
428
.. Service space (Fig. -)
Models
PE(H)-2.5, 3
PE(H)-4
PE-5, 6/PEH-5
PEH-6
A Intake
B Outlet
C Drainage pan
D Suspension bolts pitch
E Electrical parts box
F Service space
3.1. Checking the indoor unit accessories (Fig. 3-1)
Check that the indoor unit is equipped with the following parts and accessories:
A Refrigerant pipe parts
1 Pipe cover (for refrigerant piping joint)
Small diameter × 1
Large diameter × 1
2 Bands for temporary tightening of pipe cover × 4
B Remote controller parts
3 Parts contained in the cardboard box × 1
Check the contents and read the explanations provided.
A B
650 690
920 960
1120 1160
1306 1346
3