Bc10 Basic Controller; Operating The Bc10 Basic Controller; Switching The Heating System On And Off; Displaying The Operating Conditions Of The Burner And Resetting The Burner Or Resetting Burner Faults - Buderus logamax plus gb142-24 Installation Manual

10 BC10 basic controller

10.1 Operating the BC10 basic controller

110
100
90
1
Fig. 42 BC10 basic controller – Controls
pos. 1: Main switch
pos. 2: DHW temperature knob
pos. 3: LED "DHW status"
pos. 4: Display
pos. 5: Space heating water temperature knob
pos. 6: LED "Heating system status"

10.1.1 Switching the heating system on and off

Switching on the heating system
Set the main switch on the BC10 basic controller to
position "1" (On).
Switching off the heating system
Set the main switch on the BC10 basic controller to
position "0" (Off).
10.1.2 Displaying the operating conditions of the
burner and resetting the burner or resetting
burner faults
Displaying the operating conditions of the burner
The LED indicates the operating condition of the burner.
LED Condition Explanation
On Burner The water in the boiler is being heated.
operational
Off Burner off The water in the boiler has reached the
required temperature or there is no heat
request.
Table 7 LED indication
We reserve the right to make any changes due to technical modifications!
Installation instructions Logamax plus GB142-24/30/45/60 • version 10/2007
2 3 4
110 130
120
90
130
140
12 11 10 9
BC10 basic controller
5 6
150
170
190
8
pos. 7: Under the cover a RC system controller can be installed
(not available).
pos. 8: LED "Burner Operation"
pos. 9: Service Tool connector
pos. 10: "Service"
pos. 11: "Chimney sweep"
pos. 12: "Reset"
7
e
button
d
button
c
button
Buderus • http://www.buderus.net
10
39