[Ptz] Group - Cisco WVC210 Reference Manual

Network Camera Configuration File Spec V1.03
Configuration File Format
Cisco Small Business Network Camera Exported CGI Commands

[PTZ] Group

Parameter
PtzMode
PtzMdMutex
GotoMdPosIdleEn
GotoMdPosIdleVal
Preset1Name ...
Preset9Name
Preset1Position ...
Preset9Position
Patrol 1 Position
PredefineHome
Value and Description
Set pan and tilt control. The choices are:
•
0 — Off
•
1 — On
Set pan and tilt options during motion detection. The
choices are:
•
0 — Disable Pan/Tilt while motion detection is enabled.
•
1 — Disable Motion Detection when camera is out of set
motion detection area.
•
2 — Allow motion Detection in all position.
Set the flag to control whether the camera goes to the
set motion detection area after the idle timer ends. The
choices are:
•
0 — Disable
•
1 — Enable
Set the idle timer. The range is in seconds, from 60 to
900.
Set the name of preset position n. It can include up to 16
ASCII characters.
Set the coordinates (x,y) of preset position n. The format
is X,Y. The range for X
to 28.
Group a total of 20 positions. Form is as follows:
<preset position#>,<time in seconds>;
<preset position#>,<time in seconds>;...
For preset position, use the pt_position name. For time
in seconds, the range if from 5 to 60 seconds.
Set the user defined HOME position (x,y).
-63 to 63. The range for Y
is
A
-36
is
73