Connecting The Power Supply - Janome memory craft 15000 Instruction Manual

Janome 15000 Instruction Manual
e
e
www.toews.com
q
w
r
q
u
y
w
r

Connecting the Power Supply

z First make sure the power switch q is off.
x Insert the machine plug w of the power supply cord
into the power inlet e.
c Insert the power supply plug r into the wall outlet t,
and turn the power switch q on.
q Power switch
w Machine plug
e Power inlet
r Power supply plug
t Wall outlet
NOTE:
Make sure to use the power cable that came with the
machine.
If you turn off the power switch, wait for 5 seconds
before turning it on again.
WARNING:
While in operation, always keep your eyes on the
t sewing area, and do not touch any moving parts such
as the thread take-up lever, handwheel or needle.
Always turn off the power switch and unplug the
machine from the power supply:
- when leaving the machine unattended.
- when attaching or removing parts.
- when cleaning the machine.
Do not place anything on the foot control.
If you wish to use the foot control, pull out the cord from
the foot control and insert the pin connector into the jack
on the machine (see page 6).
z First make sure the power switch q is off.
x Insert the machine plug w of the power supply cord
into the power inlet e.
c Draw out the cord from the foot control and insert the
pin connector y into the jack u on the machine.
v Insert the power supply plug r into the wall outlet t,
and turn the power switch on.
q Power switch
w Machine plug
e Power inlet
r Power supply plug
t Wall outlet
y Pin connector
t
u Jack
NOTE:
• The start/stop button does not work when the foot
control is connected.
• The foot control cannot be used in the embroidery
mode.
• Do not depress the thread cutter switch when
inserting the pin connector y into the jack u.
Operating Instructions:
The symbol "O" on a switch indicates the "off" position of
the switch.
Foot controller Model 21390 is for use with sewing
machine MC15000.
For the U.S.A. and Canada only
Polarized plug (one blade wider than the other):
To reduce the risk of electric shock, this plug is intended
to t in a pola rized outlet only one way. If it does not t
fully in the outlet, reverse the plug. If it still does not t,
contact a qualied electrician to install the proper outlet.
Do not modify the plug in any way.
8
Janome Memory Craft 15000
MC15000 Owners Manual/ User Guide