Table of Contents
Advertisement
Safety and Security
Occupant safety
2 Hook
3 Anchorage ring
Securely fasten hook 2 to anchorage
ring 3.
i
For safety, make sure hook 2 has attached
to ring 3 beyond the safety catch, as illustrat-
ed.
Once the top tether anchorage hook is
attached, the child restraint itself can be
secured. Tighten the top tether strap
according to the child restraint manufac-
turer's instructions.
86
Child seat anchors – LATCH type
This vehicle is equipped with two LATCH
(Lower Anchors and Tethers for CHildren)
type anchors (at each of the rear seats) for
the installation of a "LATCH" child seat
with the matching mounting fittings.
The anchors are located behind an uphol-
stery blend.
1 Indicates the position of the anchors
2 Anchors
Lift upholstery blend up to access the
anchors.
Install child seat according to the
manufacturer's instructions.
i
Non-LATCH type child seats may also be
used and can be installed using the vehicle's
seat belt system. Install child seat according to
the manufacturer's instructions.
Warning!
Children too big for a toddler restraint must
ride in seats using regular seat belts. Posi-
tion shoulder belt across chest and shoul-
der, not face or neck. A booster seat may be
necessary to achieve proper seat belt posi-
tioning for children over 41 lbs until they
reach a height where a lap/shoulder belt fits
properly without a booster.
Install child seat according to manufactur-
er's instructions.
The child seat must be firmly attached to the
right and left side anchors 2.
G
Advertisement
Table of Contents
