Table of Contents
Advertisement
The SmartKey with KEYLESS-GO must be
located in the vehicle.
Make sure the automatic transmission
is set to P.
Do not depress the brake pedal.
KEYLESS-GO start/stop button
1 USA only
2 Canada only
Position 0
Before you press the KEYLESS-GO
start/stop button, the vehicle's on-board
electronics have status 0 (as with
SmartKey removed).
Position 1
Press the KEYLESS-GO start/stop but-
ton once.
This supplies power for some electrical
consumers, such as seat adjustment.
i
If you now press the KEYLESS-GO
start/stop button
once again, the ignition (position 2) is
switched on
twice, the power supply is again switched off
Ignition (or position 2)
Press the KEYLESS-GO start/stop but-
ton twice.
This supplies power for all electrical
consumers.
All lamps (except high beam headlamp
indicator lamp and turn signal indicator
lamps unless activated) in the instru-
ment cluster come on. If a lamp in the
instrument cluster fails to come on
when the ignition is switched on, have
it checked and replaced if necessary.
Controls in detail
Starter switch positions
If a lamp in the instrument cluster re-
mains on after starting the engine or
comes on while driving, refer to "Lamps
in instrument cluster" ( page 544).
i
If you now press the KEYLESS-GO
start/stop button once, the power supply is
again switched off.
i
When you switch on the ignition, the indica-
tor and warning lamps (except high beam head-
lamp indicator lamp and turn signal indicator
lamps unless activated) in the instrument cluster
come on. The indicator and warning lamps (ex-
cept high beam headlamp indicator lamp and
turn signal indicator lamps if activated) should go
out when the engine is running. This indicates
that the respective systems are operational.
For information on starting the engine us-
ing the KEYLESS-GO start/stop button,
see "Starting with KEYLESS-GO*"
( page 360).
317
Advertisement
Table of Contents
