1 - 5 Wheel bolts
Tighten the five wheel bolts evenly,
following the diagonal sequence illus-
trated (1 to 5), until all wheel bolts
are tight. Observe a tightening torque
of 96 lb-ft (130 Nm).
Warning!
Have the tightening torque checked after
changing a wheel. The wheels could come
loose if they are not tightened to a torque of
96 lb-ft (130 Nm).
Disassemble the pump handle
( page 392).
Put the pump handle and the wheel
wrench back into the vehicle tool kit.
Store the vehicle tool kit in the
designated storage compartment
( page 366).
Press the jack piston in again and close
G
the lowering screw ( page 392).
Store the jack in the designated
storage compartment ( page 367).
After changing the wheel, secure the
damaged wheel on the spare wheel
carrier ( page 369). Make sure the
wheel cannot come loose.
Check the tire inflation pressure and
correct it if necessary.
Follow recommended cold tire inflation
pressures listed on the Tire and
Loading Information placard on the
driver's door B-pillar ( page 280).
Practical hints
Flat tire
395