Dunkirk 95M-200 Control Manual And Troubleshooting Manual page 24

Display shows Info until a key is
pressed
Press and Hold Key(s) in BLACK (1)
[MODE] [STEP] [STORE] [+] [-]
(1) Digits after fl ashing dot show measured outlet temperature.
(2) Digits after fl ashing dot show -18.
(3) Digits after fl ashing dot show outside temperature.
(4) Digits after fl ashing dot show target outlet temperature.
(5) Digits after fl ashing dot show rate of change in °F per second.
(6) Digits after fl ashing dot show -32.
NOTE: Display will show A-32 if [STEP] is pressed after "9" appears.
10 - USER INTERFACE QUICK REFERENCE
INFORMATION MODE
Press [MODE] button 2 times from Standby Mode.
Info Then displays Parameter, Flashing Dot, and Current Status.
Duration Result
Step to next
Tap
parameter
Measured outlet water temperature
(First digit shows 1 and dot fl ashes) (1)
Return water temperature
(First digit shows 2 and dot fl ashes) (1)
This function not used
(First digit shows 3 and dot fl ashes) (2)
Outside temperature
(First digit shows 4 and dot fl ashes) (3)
This function not used
(First digit shows 5 and dot fl ashes) (2)
Target outlet water temperature
(First digit shows 6 and dot fl ashes) (4)
Outlet water temp. change over time
(First digit shows 7 and dot fl ashes) (5)
Return water temp. change over time
(First digit shows 8 and dot fl ashes) (5)
This function not used
(First digit shows 9 and dot fl ashes) (6)
24
1.190
Display
1.180
2.150
3.-18
4. 42
5.-18
6.190
7. 1
8. 1
9.-32