Preparations - Sony SPP-VT11 Operating Instructions Manual

Preparations

1
Connecting the base phone
Connect the base phone to the telephone outlet and to an AC outlet.
Antenna
to an AC outlet
(AC 100V)
AC power adaptor
Cord hook
1 Connect the receiver to the base phone
and place it on the base phone.
2 Connect the telephone line cord to the
base phone and to a telephone outlet.
3 Connect the AC power adaptor to the DC
IN 9V jack and to an AC outlet (AC 100V).
4 Raise the antenna. Make sure it points
towards the ceiling.
(TokyoDenwa auto connect.2)
Please read the following before you use the
phone.
This phone is ready to use "TokyoDenwa auto
connect.2", which automatically connects either
local or long-distance calls to TTNet that is
cheaper. There is no registration fee nor basic fees.
This feature is activated a few days after you have
connected the base phone. You only have to pay
the charges for the calls you make through
TokyoDenwa to the TTNet (NTT basic fees apply
as usual).
110
to DC IN 9V
to the telephone line jack
click
Be sure to insert the
plug firmly.
Route the cord
through the cord
hook to prevent it
from coming off.
Receiver
click
click
Telephone line cord
After you connect the AC power adaptor, the unit
starts initializing the built-in answering machine.
Wait for approximately 30 seconds until a beep is
heard.
Notes
• Insert the receiver cord and the telephone line cord until
the plugs snap in place.
• Do not bundle the telephone line cord or the AC power
adaptor cord. If you do, interference noise may be
heard.
IF you do not want to use "TokyoDenwa auto
connect.2"
Press , ,
7
flash/program
continuously with the receiver placed on the base
phone.
If you have any questions, please call toll-free:
TTNet Customer Service Center
0081-1581 (open throughout the year) or
0120-158-165
Receiver cord
to a
telephone
outlet
click
Telephone line
jack
Insert the plug until
it snaps in place.
and
0
flash/program