Releasing Seat Belts; Locking - Mercedes-Benz 2006 SL 500 Operator's Manual

Sl-class
Table of Contents

Advertisement

Releasing seat belts

Press the seat belt release button
( page 47).
Allow the retractor to completely re-
wind the seat belt by guiding the latch
plate.
!
Make sure the seat belt retracts fully so
that the seat belt and/or latch plate
cannot get caught or pinched in the
door or in the seat mechanism. This
can damage the seat belt and impair
the effectiveness of the seat belt,
and/or cause damage to the door
and/or door trim panel. Such damage
is not covered by the Mercedes-Benz
Limited Warranty.
Damaged seat belts must be replaced.
Contact an authorized Mercedes-Benz
Light Truck Center.

Locking

Warning!
To prevent possible personal injury, always
keep hands and fingers away from the door
openings when closing the doors. Be espe-
cially careful when small children are
around.
Before closing doors, make sure that there
is no possibility of someone getting caught
in a door during closing.
Warning!
When leaving the vehicle, always remove the
SmartKey or the SmartKey with
KEYLESS-GO* from the starter switch, take
it with you, and lock the vehicle. Do not
leave children unattended in the vehicle, or
with access to an unlocked vehicle. Unsu-
pervised use of vehicle equipment may
cause an accident and/or serious personal
injury.
Parking and locking
i
If you hear a warning signal you have
either
G
forgotten to turn off the lights be-
fore opening the driver's door
In addition the message
lamps
appears in the multifunction
display.
or
tried to turn off the engine while the
gear selector lever is not in P
In addition the message
lector lever to P
G
multifunction display.
Turn off the lights or place the gear se-
lector lever in P.
Getting started
Turn off
Gear se-
appears in the
61

Advertisement

Table of Contents
loading

Table of Contents