Releasing Seat Belts - Mercedes-Benz 2008 S550 Operator's Manual

Controls in detail
Driving and parking
Turning off with KEYLESS-GO*
Press the KEYLESS-GO start/stop
button ( page 346) to turn off the en-
gine.
With the driver's door closed, the start-
er switch is now in position 1. With the
driver's door opened, the starter switch
is set to position 0, same as SmartKey
removed from starter switch
( page 344).
i
In an emergency you can turn off the engine
while driving by pressing and holding the
KEYLESS-GO start/ stop button for approxi-
mately 3 seconds.
!
KEYLESS-GO*:
If you turn off the engine using the KEYLESS-GO
start/stop button and open a front door, the
transmission will shift to park position P
automatically.
Keep in mind that turning off the engine using
the KEYLESS-GO start/stop button alone only
will automatically shift the transmission to
neutral position N.
398

Releasing seat belts

Press the seat belt release button
( page 369).
Allow the retractor to completely re-
wind the seat belt by guiding the latch
plate.
!
Make sure the seat belt retracts fully so that
the seat belt and/or latch plate cannot get
caught or pinched in the door or in the seat
mechanism. This can damage the seat belt and
impair the effectiveness of the seat belt, and/or
cause damage to the door and/or door trim pan-
el. Such damage is not covered by the
Mercedes-Benz Limited Warranty.
Damaged seat belts must be replaced. Contact
an authorized Mercedes-Benz Center.