Ferroli F24 Installation, Service And User Instructions Manual page 46

l l
In the e ent of the red lockout light (
the spring tension to the reset position and released (this will put the boiler into three minute delay if in the heating
mode). If the lockout light (
In cold weather the boiler may appear to run when there is no demand for heating (i.e. clocks or room
thermostats turned off). This is due to the central heating sensor going into frost protection mode. Once
the boiler has reached 1 °C or more it will close down until either the temperature again falls below 7°C
or the clock or room thermostat is turned on.
For this reason we recommend that the electricity to the boiler is left turned on. If you wish to turn off the electricity
to the boiler in winter you should drain completely the heating and hot water circuits.
Cl a g
The casing re uires no special cleaning a wipe with a soft duster or damp cloth will suf ce.
a a
F rroli recommend that the appliance is ser iced a l a
engineer.
a l
It is the law that all gas appliances are installed and ser iced by a competent person in accordance with
the Gas Safety Regulations (Installation & Use) 199
these re uirements may lead to prosecution.
l al l
WARNIN - T a l a
The electrical wiring must be carried out by a competent electrician.
The colours of the wires in the mains lead of this appliance may not correspond with the coloured markings
identifying the terminal in the plug. Therefore proceed as follows
The wire coloured green and yellow must be connected to the terminal in the plug marked with either the letter
or by the earth symbol or coloured green or green and yellow. The wire coloured blue must be connected to
the terminal marked either with the letter
the terminal marked either with the letter
INI C ARANC
The minimum clearance around the appliance should be as follows
Sides 5mm
Front 00mm
Below 200mm
Abo e 100mm Top Flueing
) coming on the on off reset switch (A) should be turned clockwise against
) illuminates repeatedly contact an appro ed F rroli ser ice engineer.
and the manufacturers instructions. Failure to obser e
b a d.
or coloured black. The wire coloured brown must be connected to
or coloured red.
l by a competent