Advertisement
7
Install 10 x 15W Max Candelabra bulb.
Bulbs included. Warning: Over lamping
the fan will result in the fan lights shutting
down until the proper wattage of bulbs
are installed. Reset the lights by turning
off, replace bulbs with the correct
wattage bulbs, turn the power on.
Caution: Do not replace bulb until it
cools down.
10
ON
Dip switches
Set dip switches on the Remote
Transmitter and Remote Receiver to the
same settings. This must be done so the
units will communicate properly. If you
have other fans you can set to control
from one Transmitter by setting
receivers the same as the Transmitter. If
you have more than one fan with remote,
you can set the dip switches to different
positions to have separate control
© 2013 Monte Carlo Fan Company
8
Install ball end of downrod into mounting
bracket opening. Align (engage) slot on
ball with tab on mounting bracket.
Warning: Failure to align slot on ball with
tab may result in serious injury.
11
11
Wall Switch
Power
White
Line
Black
Grounded/
Green
White
Make wiring connections using wire
connectors provided as indicated above.
White from fan to White from remote
marked N. Black from fan to Black from
remote marked L. Blue from fan to Blue
from remote marked FOR LIGHT. White
from house to White from remote marked
AC N. Black from house to Black from
remote marked AC L. Connect all green
grounded wires to Grounded wire from
House. Make sure that no filaments are
outside of the wire connectors.
Insert the remote receiver into mounting
bracket.
4
9
Tab
Lag screw
Slot
Safety cable
Washer
Lock washer
For Canadian installation and for USA fan
and light kit combinations over 35 lbs, in
both flush and downrod modes the safety
cable must be installed into the house
structure beams using 1.5" lag screws,
washers and lock washers provided.
Make sure that when the safety cable is
fully extended the lead wires are longer
than the cable and no stress is placed on
the lead wires.
Note
: If Installing The Secondary Support
Safety Cable in the U.S., Do Not Remove
Knockouts In The Outlet Box.
12
Black
White
Blue
Black
Loosen one and remove one
preassembled canopy mounting screw
from mounting bracket. Save canopy
mounting screw.
SAFETY CABLE INSTALLATION
9/23/2013
Advertisement
