Advertisement
1
Before you begin installing the fan, Switch
power off at Service panel and lock
service disconnecting means to prevent
power from being switched on
accidentally. When the service
disconnecting means cannot be locked,
securely fasten a warning device, such
as a tag, to the service panel.
BUILDING STRUCTURE METHOD
4
Outlet box
Mounting
bracket
Wood screw
Secure mounting bracket directly to a
joist from the buliding structure. Use only
the appropriate wood screws and
washers included with your fan. Caution:
Wood screws must go through into the
building joist.
Note:If Installing It In The U.S., Do Not
Remove Knockouts In The Outlet Box
© 2013 Monte Carlo Fan Company
2
Before installing this fan make sure the
outlet box is properly installed to the
house structure. To reduce the risk of
fire, electric shock, or personal injury,
mount to outlet box or supporting system
acceptable for fan support.
(Mounting must support at least 50 lbs.)
5
Downrod
Canopy
Keeper
pin
Yoke cover
Cross pin
Downrod
Remove preassembled keeper pin and
cross pin from downrod.
Place downrod over canopy and yoke
cover, thread lead wires and safety cable
from motor assembly through downrod.
3
OUTLET BOX METHOD
3
For Installation in The U.S. only
Mounting bracket
Use metal outlet box suitable for fan
support and use only the screws provided
with the outlet box (must support 50
lbs). Before attaching fan to outlet box,
ensure the outlet box is securely fastened
by at least two points to a structural
ceiling member (a loose box will cause
the fan to wobble). Remove the two outlet
box screws provided with the box,
aligning the holes of the mounting
bracket with the holes of the outlet box.
Reinstall the 2 outlet box screws
securely.
6
Downrod
Yoke
Partially loosen downrod set screws from
yoke at top of motor assembly.
Slip downrod into motor housing yoke,
aligning holes and install cross pin and keeper
pin.
Insert cross pin through yoke and downrod
until point appears on the other side, and
insert keeper pin on cross pin.
Pull the downrod up tight against the cross
pin, and then evenly tighten the downrod set
screws on motor housing yoke.
Place yoke cover on top housing of fan.
Warning: Cross pin and keeper pin must be
installed securely, failure to install them will
result in serious injury.
Keeper
pin
Cross pin
9/23/2013
Advertisement
