Installation - Black Box FX6306NA User Manual

PLUG AND PLAY PHONE LINE MANAGER XL

3. Installation

Select an appropriate location away from direct sources of heat or cold. The
Plug and Play Phone Line Manager XL can be stacked on a desk or table, or
mounted vertically on a wall. Typically the Plug and Play Phone Line Manager
XL is located in the same area as other computer network or telephone
equipment. All device and power connections are made in the rear of the
unit. All connections or disconnections must be made with power removed from the
unit.
The FX1236NA and FX1648NA mount in a 19" rack. First, locate the four pre-
drilled holes in the bottom of the faceplate and front of the shelf. Align the
faceplate holes with the shelf holes and then insert the screws through the
holes. Place the nylon insert nuts onto the back of the screws. Tighten the
screws until hand-tight. Now you can mount the shelf in a standard 19" rack
using the supplied 10-32, 1 ⁄ " long truss-head screws. Once the shelf is
2
mounted, the units can be placed on the shelf with front-panel LEDs facing
forward or with the RJ-11 connectors facing forward for patch-panel
applications.
We have included both self-adhesive feet and an adhesive-backed hook & loop
fastener. The feet are useful when the unit will be resting on a flat surface.
The hook & loop fastener is useful when mounting the unit to a wall or other
vertical surface. The hook & loop fasteners also provide rackmount stability
when installed between the two Phone Line Manager units on the 12 x 36 and
16 x 48 models. To use the hook & loop fastener, keep the hook and loop
halves together while peeling the plastic backing from one side and stick it to
one of the bottom corners of the unit. Repeat the process for all four corners.
Now peel the remaining plastic backing from the hook and loop halves.
Carefully line the Plug and Play Phone Line Manager XL up where you want
to mount it and press the unit firmly to the mounting surface. Once installed
using the hook & loop fastener, the unit may be removed from the mounting
surface by grasping the unit and pulling firmly away from the mounting
surface. To remount, align the hook & loop halves together and press firmly
together.
12