Outgoing Calls; Data-Transmission Speed - Black Box FX6306NA User Manual

CHAPTER 4: Operation

4.2 Outgoing Calls

Any IST device connected to a port on the Plug and Play Phone Line
Manager XL can access dial tone to make an outbound call. The number of
IST devices that can be in use simultaneously is equal to the number of
telephone lines connected to the Plug and Play Phone Line Manager XL and
enabled for outgoing access via SW1 positions 1 through 3 for the Plug and
Play Phone Line Manager XL 3 x 6, SW1 positions 1 through 4 for the Plug
and Play Phone Line Manager XL 4 x 12, and both SW1 and SW2 positions 1
through 4 for the Plug and Play Phone Line Manager XL 8 x 24.
Outgoing calls will cause the IST Port LED and the Line Port LED to light
solid. If none of the Line Ports are available (busy on another call with
another IST Port), then the originating outgoing IST Port LED will flash until
an outgoing Line Port does become available. If any of the Line Ports have
Line Present Switch (SW1 and/or SW2) set to ON, and there is no Line
attached, the Line Port LED will flash and then pass the call to the next Line
Port. When an available Line Port is accessed, both the IST Port and the Line
Port LEDs will light solid and remain ON throughout the duration of the call.
When an IST device hangs up (goes on-hook) and terminates the outgoing
call, the IST Port LED will go out first and the Line Port LED will flash for 3
seconds (to allow the line to stabilize) before another IST Port can access the
line for dial tone and outgoing calls.

4.3 Data-Transmission Speed

The Plug and Play Phone Line Manager XL is transparent to speed.
21