Printer Controller Software And Fonts - Xerox DocuPrint 4850 NPS System Overview Manual

PRINTER CONTROLLER

Printer Controller software and fonts

2-4
External Modem
•
US Robotics Courier V. Everything 56KB V.90 External Voice/
Data Fax/Modem and serial cable.
Cartridge tape drive (optional)
•
150 MB, 1/4-inch, SCSI cartridge tape drive
•
8 GB, 4mm, SCSI cartridge tape drive
Note: Printer Controller hardware configurations are subject to
upgrade.
The installation of Printer Controller software is performed by your
service representative once all the hardware components are in
place and properly connected. The following is a summary of major
software components installed on the Printer Controller:
•
Xerox Printer Controller software
— Customized UNIX operating system (based on the Sun
operating system; not all standard operating system
features are available).
— DocuPrint NPS software for the user interface, printer
driver, PDL decomposer, Job Pool Manager, and other
operating system utilities. Licensing is required for the
DocuPrint NPS software.
— Xerox client protocol software (print command)
downloaded to client workstations or PCs as a means to
communicate with the Printer Controller.
•
Adobe PostScript fonts
Using font installation commands, you can load other Type 0,
Type 1, or Type 3 PostScript fonts from a MS-DOS-formatted,
3.5-inch diskette or CD-ROM disk. Type 0 fonts must conform to
a specification available from Xerox. Refer to the Xerox
DocuPrint Network Printer Series Guide to Configuring and
Managing the System, "Installing fonts," for more information on
font installation commands. Type 0, Type 1 and Type 3
PostScript fonts can also be downloaded with a print job. Refer
to the Xerox DocuPrint Network Printer Series Guide to Using
PDL, "PostScript," for more information on PostScript fonts.
•
PCL fonts
One bitmap font and 45 scalable PCL fonts are preinstalled on
the system. A PCL font sampler is also preinstalled on the
system. The 45 scalable and bitmap font files are listed in table
2-2. Additional fonts can be installed. Refer to the Xerox
DocuPrint Network Printer Series Guide to Using PDL, "PCL 5,"
for more information on PCL fonts.
•
MICR fonts
For 96/4635/180 MICR systems, E13B fonts in PCL and
PostScript are also provided.
XEROX DOCUPRINT 4850/4890 NPS SYSTEM OVERVIEW GUIDE