Xerox DocuPrint 4850 NPS System Overview Manual page 26

PRINTERS
Message display
Wire percentage indicator
Feeder tray indicators
Power on/off switch
Continue button
Fault code display
3-4
Printer status and simple operating and maintenance instructions are
shown in a two-line message. One of the following icons indicates the
printer mode:
Also in the lower panel, the dry ink color currently loaded is shown.
Graphic display The graphic display shows a specific area of the printer requiring
attention. The graphics help you locate the area where the problem
occurred.
Displays the percentage of stitcher wire remaining on the spool. This
display appears only if your printer has the stitcher/stacker output
configuration.
These lights indicate the selected feeder tray or trays and the size of
paper loaded in each tray.
This switch controls power to the printer and is used primarily by
service representatives.
Sample button Not used. The sample feature is not available on 4850/4890.
The Continue button resumes printing when it is pressed.
While it is formatting a complex page, the Printer Controller may
cycle down the printer if the page image is not available within a
certain time frame. If this occurs, the following message appears:
Press <CONTINUE> to resume printing
You can ignore this message. As soon as the page image is
available, the Printer Controller cycles up the printer and printing
automatically resumes.
Stop button Pressing the Stop button halts printing without interrupting input
processing.
Shows the number of completed prints and also displays printer fault
codes (for example, L152). When a fault code displays here, a
corresponding message (for example, "Stitcher is out of wire" or
"Spool not rotating") appears in the message display.
Printer Mode
Black
XEROX DOCUPRINT 4850/4890 NPS SYSTEM OVERVIEW GUIDE
Highlight