Programming Remotes - Genie IntelliG Setting Limits & Remote Programming

Setting Force & Speed:
10
Open and close your garage door using the Wall
Console Open/Close button.
Force and speed are set.

Programming Remotes:

14
Press and hold the Program Set button (the round
LED turns blue).
PROGRAM
SET
HOLD
2 seconds
15
Release the
Program Set button
begins flashing purple).
PROGRAM
SET
16
Remove protective film for battery from remote.
To clear remote memory completely from the power head -
Press the Program Set button on the power head and hold for
2 seconds. The round LED will come on. Release the Program
Set button and the round LED goes off. The long LED now
flashes purple. Press the up arrow button and down arrow
button simultaneously on the power head and hold until both
LEDs flash blue and go off.
– +
(the long LED
– +
17
Press and release the button you have chosen
on the Remote (long LED comes on purple).
PROGRAM
SET
18
Press and release the same button on the remote
(both LED's flash blue and then turn off).
PROGRAM
–
SET
19
Press and release the same button on the remote
(the door should open or close).
+
–
PROGRAM
–
SET