Electronic Monitor - GE 49-60067 Use And Care Manual

ELECTRONIC MONITOR & DIAGNOSTIC SYSTEM
How the Electronic Monitor and Diagnostic System Works
The Electronic Monitor and Diagnostic System alerts you when
something starts to go wrong.
If a diagnostic code appears on the display, something needs
special attention. To get your attention, the display code flashes
until you erase it. The first 6 flashes are accompanied by beeps.
If more than one coded function requires attention at the same
time, the one with the highest priority will be displayed first.
Pressing this pad will evaluate all other coded
functions. If the display is lit during the displaying
of a code, that function is operating properly.
Pressing this pad will erase two codes
immediately—PF and CI. The dE and FF codes can
only be erased after the condition that caused the
code to flash has been corrected.
This flashing code tells you to check your
frozen food. Has any of it started to thaw? A
package may be holding the freezer compartment
door open. Don't open the door more often than
absolutely necessary while this code is displayed.
Touching the pad after the freezer compartment
temperature has returned to normal will erase
the code.
This flashing code tells you to check the
automatic icemaker. Ice clumps in the storage
bin may have stalled the icemaker. Follow
corrective measures described in the Problem
Solver. If water supply to the icemaker is not
connected or not turned on, make sure manual
icemaker switch is in the (up) position. This
code stops flashing when problem is corrected or
the pad is touched.
6
(continued)
This pad is lighted except when a
failure has been detected.
This pad has two functions:
1. You can touch this pad and get a review of the
electronic diagnostic codes in order of their priority.
2. You can touch this pad to erase three flashing codes
immediately and two codes after the condition that
caused them to flash has been corrected.
This flashing code tells you the power to the
refrigerator has been interrupted for more than
two seconds. Check the condition of food in both
the fresh food and freezer compartments. Touch the
pad to erase code.
There is no fault with the refrigerator when the
PF code flashes.
This flashing code tells you something is wrong
with the defrost system—keep doors closed to
retain cold and call for service. Code flashes until
problem is corrected.