GE 49-60067 Use And Care Manual page 5

ELECTRONIC MONITOR & DIAGNOSTIC SYSTEM
It Keeps an Eye on Things for You
4
1 3
7
This pad flashes to tell you when either door is open.
This pad lights up to tell you that the Door Alarm beeper has been
set to sound after either door has been open 30 seconds.
This pad lights up to tell you when freezer food-keeping
temperature is above normal.
This pad lights up to indicate that no failure has been detected by
the diagnostic system.
When Your Refrigerator is First Plugged in
All panel lights come on for five seconds, a beep sounds, and lights go
off except as follows:
• PF flashes in the display. Touch this pad to erase it.
• This pad glows.
• The Warm Temperature light glows if the freezer
compartment temperature is higher than normal.
It goes off when proper food-keeping temperature
is reached.
How to Set the Door Alarm
You don't have to set the visual alarm.
As long as either door is open, this pad flashes.
When the Door Alarm pad is glowing, the beeper
alarm is set. If it's not, touch the pad to turn it on.
If either door is open for more than 30 seconds, a
repeating sound will be heard.
The light goes out and the beeping stops when you close the door.
There are times when you'll want the Door Alarm beeper turned
off. When you're rearranging a lot of food, for example. Just touch the
pad. The light will go out and the beeping will stop.
Turning off the Door Alarm beeper does not turn the
Door Open pad off—it keeps flashing until the door
is closed.
(on some models)
5
6
2
7
The flashing diagnostic codes in the display warn you when:
frozen foods should be checked.
power has been interrupted.
icemaker may not be operating properly.
defrost system has failed.
This pad allows you to review the electronic diagnosis of four
coded functions at your fingertip and also allows you to erase
codes from display.
These pads allow you to select:
chilled water,
• The Door Alarm beeper is activated and the Door
Alarm pad glows.
• The Crushed Ice pad glows.
• This pad flashes if either door is open, goes out
when doors are shut.
• The night light in the water-and-ice dispenser is off.
Why the Warm Temperature Light Glows
At first, it's probably because your newly installed
refrigerator hasn't completely cooled down yet. Wait
a few hours for it to cool, and then the light will go out.
From then on, the pad will glow whenever
temperatures inside get too high for proper food
storage. If this happens, open the doors only when
absolutely necessary, and close them as quickly as possible.
As soon as inside temperatures return to normal, the light goes out.
If the Warm Temperature light reappears and stays on for longer than
4 hours, call for service.
ice cubes or crushed ice.
(continued next page)
5