Raymarine AIS350 Installation Instructions Manual page 53

remove these tabs before using the cable channel, you could
damage the cable.
A
2
4
T op view
2. Screw the two mounting studs (2) into the underside of the
receiver.
3. Stick the supplied gasket (3) to the mounting surface, ensuring
that the holes on the gasket correspond with the drilled holes.
4. Route the cable as follows:
• For Option A, feed the cable down through the center hole.
• For Option B, route the cable along the cable exit channel.
5. Carefully place the receiver so the mounting studs pass through
the holes in the mounting surface.
6. Secure the receiver to the surface using the two thumb nuts (4).
AIS650 Class B transceiver
B
3
2
4
Underside view
Pole mounting
If you want to pole-mount the GPS antenna, obtain a pole of suitable
length with a 1 inch 14 TPI thread.
1
Antenna
3
Pole mount adaptor
1. Ensuring that the Site requirements are met, securely attach the
pole to a suitable, secure point.
2. Remove and retain the screws securing the GPS antenna from
the pole mount adaptor, then separate these two items.
3. Screw the pole mount adaptor fully onto the pole and ensure
it is secure on the pole.
4. Route the antenna cable as follows:
i. If you want to route the antenna cable directly down from
the antenna (option A), feed it through the center of the pole
mount adaptor and then down through the pole.
A B
53