Conversion Instructions; Unit Adjustments - Jenn-Air JGW8130DD series Service Manual

Conversion Instructions

%DNH DQG %URLO %XUQHU /33URSDQH *DV &RQYHUVLRQV
`lksboq mobpprob obdri^qlo colj k^qro^i d^p ql imLmolm^kb d^p
fjmloq^kqW
Save all natural gas orifices removed from the appliance for possible future conversion to natural gas.
Remove the oven door and all racks and follow the steps outlined below.
NK `lksbopflk lc _^hb _rokbo lofcf`b mirdW
a. Remove oven bottom and then the burner orifice
cover.
b. Remove (3) screws, (2) burner and (1) shutter. Then
slide the burner out of the orifice shutter. Set the
burner to the side of the oven. Care should be taken
not to damage the igniter wire leads.
c. Remove the orifice plug with 5/8² socket wrench.
The shutter will come off with the orifice plug.
d. Replace the Natural orifice plug with the LP plug
and secure it and the shutter back in place with the
5/8² socket wrench.
`^rqflkW
Use care not to over tighten the plug
and make sure that the shutter turns freely around
the plug.
e. Replace the burner by sliding the end carefully into
the shutter. Re-assemble the burner with the two
screws. Align the shutter slot with the screw hole
and loosely install the shutter screw (do not tighten
at this time.)
f. Adjust the burner shutter (rotating around the burner
end) for correct flame characteristics (refer to the
Unit Adjustment section). Once the proper shutter
opening is determined, tighten the shutter screw.
g. Replace the burner orifice cover and secure with the
two screws.
l“‚‹ _Œ‘‘ŒŠ
b•‰Œ‚ _Œ‘‘ŒŠ _’‹‚ s†‚”
© 2004 Maytag Services
OK `lksbopflk lc _olfi _rokbo lofcf`b
ellaW
a. Remove the burner screw and then slide the burner
b. Remove the orifice hood with 1/2² socket wrench by
c. Replace the Natural orifice hood with the LP hood
d. Replace the burner by sliding the end carefully onto
e. Adjust the burner shutter (rotating around the burner
9215-263-0
9215-264-0
16022514 Rev. 0
slightly forward until the pin on the rear of the burner
is out of the hole in the rear wall. Slip the burner off
of the brass orifice hood (see figure below). Lay the
broil burner assembly on the oven bottom. Care
should be taken not to damage the igniter wire
leads.
turning the hood counterclockwise.
(orange strip) and secure with the 1/2² socket
wrench.
`^rqflkW
Use care not to over tighten the plug
and make sure that the shutter turns freely around
the plug.
the hood. Then align and slide the pin on the burner
into the hole in the rear wall. Slide the pin toward the
rear until the front mounting slots aligns with the
screw hole. Replace the screw in the front of the
broil burner until tight.
end) for correct flame characteristics (refer to the
Unit Adjustment section). Once the proper shutter
opening is determined, tighten the shutter screw.
l“‚‹ qŒ
_Œ†‰ _’‹‚ s†‚”
9215-265-0
9215-266-0
C–3