Yaesu FT-450D Operation Manual page 82
Hide thumbs
Also See for FT-450D:
- Operation manual (102 pages) ,
- Technical supplement (98 pages) ,
- Reference book (18 pages)
Table of Contents
Advertisement
M
M
ENU
EXT MNU (EXTENSION MENU)
Function: Enables / Disables the extended Menu
Mode
Available Values: ON / OFF
Default: ON
OFF: The menu will only display the 16 most often
used items.
ON: All 62 menu mode items will be displayed.
A&FDIAL (AM&FM DIAL)
Function: Enables or disables the [ MAIN DIAL ] knob
in the AMand FM modes.
Available Values: ENABLE / DISABLE
Default: DISABLE
ENABLE: The frequency can be set with the [ MAIN
DIAL ] knob even in the AM/FM mode.
DISABLE: The [ MAIN DIAL ] knob does not change
the frequency in the AM / FM mode.
APO (APO TIME)
Function: OFF / 1~12 (h)
Available Values: ON / OFF
Default: OFF
Selects the Auto Power Off time (time before power
goes off).
BCN TIM (BEACON TIME)
Function: Selects the interval time (between mes-
sage and message)
Available Values: OFF/1~255 (sec)
Default: OFF
BCN TXT (BEACON TEXT)
Function: Stores the message for the Beacon. Up
to 118 characters may be stored.
Please refer to page 52 for storage procedure.
INPUT
DC 13.8V
22A
DATA
TUNER
Page 80
ODE
ANT
EXT
GND
SPKR
LINEAR
CAT
BEEPTON (BEEP TONE)
Function: Selects the beep frequency.
Available Values: 440 / 880 / 1760 (Hz)
Default: 880 (Hz)
BEEPVOL
Function: Selects the beep volume level.
Available Values: FIX0 ~ FIX100 or
LNK-50 ~ LNK 0 ~ LNK+50
Default: FIX10 or LNK-8
CAT RTS
Function: Enables / Disables the RTS port of the
CAT jack.
Available Values: DISABLE/ENABLE
Default: ENABLE
CAT TOT (CAT TIME OUT TIME)
Function: Sets the Time-Out Timer countdown time
for a CAT command input.
Available Values: 10 / 100 /1000 / 3000 (ms)
Default: 10
The Time-Out Timer shuts off the CAT data input af-
ter a continuous transmission of the programmed
time.
CATRATE
Function: Sets the transceiver circuitry for the CAT
baud rate to be used.
Available Values: 4800/9600/19200/38400 (bps)/
DATA
Default: 4800
The CAT baud rate is set for the transceiver.
Setting "CATRATE" to "DATA" will enable RTTY op-
eration from the CAT jack. The interconnection for
RTTY operation is shown below.
Requires the RTTY Software
(Not Supplied)
FT-450D O
M
PERATION
ANUAL
Advertisement
Table of Contents
