My Bands Operation - Yaesu FT-450D Operation Manual

R
ECEIVING
The "My Bands" feature allows you to select several Amateur bands, and make only those bands available for
selection via the [ BAND ] / [ BAND ] buttons.
This feature can be very useful in a contest, where the 10/18/24 MHz band are not used, or if you do not have
antennas for some bands.
M B S
Y ANDS ETUP
1. Press and hold the [ F ] button for one second to
enter the Menu mode again. The "
will appear on the display.
2. Rotate the [ DSP/SEL ] knob to select the menu
item "MY BAND".
3. Press the [ DSP/SEL ] knob to enable adjustment of
this menu item. The "
4. Press the [ BAND ] / [ BAND ] buttons to choose
a band you wish to skip (omit) from the band se-
lection loop.
5. Rotate the [ DSP/SEL ] knob to select "OFF", and
then press the [ DSP/SEL ] knob.
N
The "OFF" selection sets the selected band to be
skipped, while the "ON" selection sets the selected
band to be included in the band-selection list.
6. Press the [ DSP/SEL ] knob. The "
turns to appear continuously.
7. Repeat steps 4 through 6 to select/deselect as
many bands as you like.
N
The GEN (General Band) and the current band
cannot be skipped.
8. Press and hold the [ F ] button for one second to save
the new setting and return to normal operation.
M B O
Y ANDS PERATION
Press the [ BAND ] / [ BAND ] buttons to choose the
Amateur band on which you wish to operate. Only
those Amateur bands that have not been skipped will
appear as you scroll through the bands.
N
If you want to recall an operating band which has
been set to my band "OFF", Press the [F] button,
then press the [ BAND ] / [ BAND ] button until
the desired band appears.
Page 22
M B
Y ANDS
" icon
" icon will be blinking.
" icon re-
O
PERATION
[ DSP/SEL ] knob
1.8MHz
3.5 MHz
7 MHz
10 MHz 3.5 MHz
14 MHz 7 MHz
14 MHz
18 MHz
21 MHz
21 MHz
28 MHz
24 MHz
28 MHz GEN
50 MHz
GEN
FT-450D O
[ BAND ] / [ BAND ] button
[ F ] button
3.5MHz 7MHz 14MHz
« 21MHz GEN
28MHz
[ BAND ] / [ BAND ] button
M
PERATION ANUAL