Memorex MVD4540 Owner's Manual page 11

Inserting Batteries
1
Open the battery
compartment cover in the
direction of the arrow.
Battery precautions
The precautions below should be followed when using batteries in this device:
1. Use only the size and type of batteries specified.
2. Be sure to follow the correct polarity when installing the batteries as indicated in the battery compartment.
Reversed batteries may cause damage to the device. To avoid a potential short circuit, insert the "–" end first.
3. Do not mix different types of batteries together (e.g. Alkaline and Carbon-zinc) or old batteries with fresh ones.
4. If the device is not to be used for a long period of time, remove the batteries to prevent damage or injury from
possible battery leakage.
5. Do not try to recharge batteries not intended to be recharged; they can overheat and rupture. (Follow battery
manufacturer's directions.)
Remote control basics
• Press POWER to turn the DVD/VCR on or off.
• Make sure VCR/DVD switch is set to VCR/DVD.
• Tap CH or CH
• The CH / and SET +/– are also used to navigate on-screen menu system.
• You can directly access specific channels using Number keys pad.
• Each press of VCR/DVD on the remote control, switches the screen between the VCR screen (VCR mode)
and the DVD screen (DVD mode).
Operation
• Aim the remote control at the remote sensor and press control buttons
to operate.
• Operate the remote control within 30 angle on either side of the remote
sensor, up to a distance of Approx. 5 meters.
2A77001AE(06-11)
2
Install two "AAA" batteries (not
supplied), paying attention to the
polarity diagram in the battery
compartment.
to move through the channels one channel at a time.
11
Remote control
3
Replace the compartment
cover.
Approx. 5 meters
8/29/02, 10:48 AM
11