Comfort Glow SL30NT Owner's Operation And Installation Manual page 9

INSTALLATION
Continued
9. Fasten stove bottom to stove with four (4) M6 x 1 - 25mm bolts.
Use a flat washer and lock washer with each bolt. Tighten bolts
into threaded holes on stove body (see Figure 10 and Figure 8
on page 8). Use an adjustable wrench or a 10mm socket.
10. Attach stove door by inserting step bolt through door hinge
pivot holes and into threaded hole in stove body (see Figure
11). Use an adjustable wrench or a 12mm socket to fasten step
bolt. Tighten step bolt until snug. Make sure door moves freely.
11. Install door catch bolt (M8 x 1.25-55mm with two M8 hex
nuts) into threaded hole on stove body (see Figure 8, page 8).
Use an adjustable wrench or a 12mm socket. The catch bolt
has two hex nuts attached to it (see Figure 12). The top nut is a
bolt stop and the bottom nut is for door leveling adjustment.
Bolt
Leg
Figure 9 - Attaching Stove Legs
Washers
Bolt
Stove
Bottom
Figure 10 - Attaching Stove Bottom
For more information, visit www.desatech.com
For more information, visit www.desatech.com
104463-01E
12. Check general catch bolt alignment with door claw. Make fi-
13. Carefully lift stove back up on its four attached legs.
14. If available, install gas log heater inside stove cavity before
15. Fasten back panel to stove with six (6) M6 x 1 - 20mm bolts
Stove
Door
Door
Hinge
Bottom Of
Stove Unit
Step
Bolt
Figure 11 - Attaching Stove Door (Appearance May Vary
Depending on Model)
Bottom Of
Stove Unit
Figure 12 - Catch Bolt and Door Claw Orientation
Stove Cavity Assembly (Cont.) Stove Cavity Assembly (Cont.)
nal adjustment and door leveling after stove is in normal stand-
ing position.
installing the back panel (see Installing Gas Log Heater Into
Stove, page 10).
and washers. Make sure product identification label is located
on the outside in lower left-hand corner.
Threaded
Hole
Bolt
Shoulder
Stove Bottom
Door
Door Claw
INSTALLATION INSTALLATION
9 9
Stove
Door
Bolt
Shoulder
Door
Hinge
Step
Bolt
Bolt Stop
Adjusting Nut
Catch Bolt