Sharp MX-M503N Operation Manual page 213

Stamp
Move
Select the location to move the selected item.
4
If you wish to swap the position of the selected stamp item with the position of another stamp item, temporarily move
either one of the items to an unoccupied position and then switch the print positions.
Stamp
Move
Select the location to move the selected item.
5
Stamp
Layout
6
Downloaded From ManualsPrinter.com Manuals
AAA AAA
CONFIDENTIAL DO NOT COPY
1,2,3..
Touch the key of the desired destination
position.
OK
The touched position key is highlighted and the print position
changes.
The keys that show the print positions will appear as follows
depending on the state of the settings.
The above key is the top left key. The appearance of each key
varies depending on the position of the key.
Touch the [OK] key.
If you attempt to move the stamp item to a position that is
OK
already occupied by another stamp item, a message will
appear asking you if you wish to overwrite the other stamp
item. To overwrite the other stamp item, touch the [Yes] key. To
cancel the move, touch the [No] key.
Touch the [OK] key.
OK
2-101
Not selected, stamp setting has not
been selected.
Selected during selection of the stamp
setting.
Not available, stamp setting has already
been allocated.
An item has been already selected to
this location. Overwrite the item?
No Yes
Contents
COPIER