Elation PLATINUM FLX User Manual page 16

LAMP INSTALLATION PROCEDURE - [continued]
12. Be sure to reset the LAMP HOURS in the system menu to prevent the protection
circuitry from accidently shutting off the lamp during normal operation.
13. If the lamp protection circuitry has already been initiated and the LAMP HOURS is
not reset, the "Replace the Lamp" warning will continue to flash and fixture will
eventually shut down. To reset LAMP HOURS, see instructions below.
LAMP HOURS RESET PROCEDURE
1. Activate the main menu by pressing MODE/ESC and toggle to "Information".
2. Press ENTER and press UP or DOWN to toggle to "Time Information".
3. Press UP or DOWN to toggle to "LampTime Password" and press ENTER. Then press
UP or DOWN to enter the reset pass code, "038" and press ENTER to confirm. The
display will automatically revert to "LampTime Password", next press UP or DOWN
to toggle down to "Clean Lamp Time".
4. Press ENTER and select "ON". The lamp timer has now been reset, press
MODE/ESC to exit the menu and return to the home screen.
LAMP OPTIMIZATION
Unlike traditional discharge lamps the Philips
optimization. The lamp orientation and optimization procedure has been preset
during the manufacturing process of the lamp.
Please remember the Philips
therefore, you must wait approximately 15 minutes before you can attempt to
restrike the lamp once it has been turned off.
w w w . e l a t i o n l i g h t i n g . c o m
Platinum 20R Lamp does NOT require
™
Platinum 20R Lamp is NOT a hot-restrike lamp
™
16
PLATINUM FLX™ User Manual Ver. 1