P.mode Button; S.mode Button; Digital Photo Frame (Dpf) Section; Proceed With Auto Scan' And 'No Database - Pandigital PANTV1512 Kitchen Technology Center User Manual

Hide thumbs Also See for PANTV1512 Kitchen Technology Center:

Table of Contents

3. Press EXIT to close the information window.

P.MODE Button

While watching a TV program, press P.MODE to cycle through the Picture modes, and temporarily select a

different Picture Mode than the one set as the default. (Refer to VIDEO Option on page 22 for setting the

default Picture Mode.)

While watching a TV program, press S.MODE to cycle through the Sound modes, and temporarily select a

different Sound Mode than the one set as the default. (Refer to AUDIO Option on page 23 for setting the

default Sound Mode.)

WARNING: The KTC defaults to the TV mode when shipped from the factory. The first time you power it on,

you may receive the following messages.

If you are not connected to cable or a TV antenna, the first time you power the KTC on the unit will display

'Proceed with Auto Scan' and/or 'No Database' messages. Press SOURCE on the remote control or side panel

buttons, use the arrows to highlight DPF, and then press ENTER. The KTC will now be in the Digital Photo Frame

(DPF) mode, and will remain in the DPF mode until you change the SOURCE at a later time.

The PanTouch interface was designed to provide the same KTC functions as the remote control and side panel

buttons, except now the functions are conveniently hidden away in the top right corner of the frame (not on the

screen), waiting to be activated by your touch.

TIP: Throughout this User Guide, (PT) is noted next to instructions referencing specific use of the

PanTouch interface.

Table of Contents

Show Quick Links

Table of Contents