Ready To Watch Tv; No Database' Message; Initial Tuner Setup - Pandigital PANTV1512 Kitchen Technology Center User Manual

Note:
For the best results, set your PC resolution to 1280x768 at 60 Hz. The TV resolution is 1366x768, but
•
the PC resolution does not support this mode so we suggest using 1280x768 as the closest
resolution. Refer to the PC or graphic card's user guide for further instructions on how to set your
resolution and refresh rate.
Refer to your PC user guide for video output requirements of the video card.
•
The VGA port of the KTC features a power saving mode which will automatically turn off the TV if
•
there's no signal provided for more than 5 minutes.

READY TO WATCH TV?

1. Make sure your power cable is connected and the standby indicator light in the front of the KTC is red.
2. Check all your connection cables from the side or back of your KTC and also your AV devices. Make sure
they are all connected securely.
3. Power on your KTC and other AV devices if necessary.
4. If the TV does not display right away, press SOURCE to be sure TV is selected as your source (or a
different source according to the connection method you used in the Connection Suggestions pages
beginning on page 16.)

'No Database' Message

If you are connected to cable or a TV antenna, TV is selected as your source, and the message 'No Database'
appears, the KTC is not receiving a strong enough signal for the current channel to be displayed. Perform the
Initial Tuner Setup per the following instructions.

Initial Tuner Setup

The first time you power on the KTC after connecting an antenna or cable (without a cable box) follow the
instructions below to perform the initial setup and then your TV will be ready for viewing.
Note: Use the remote control to perform the OSD functions.
1. Press MENU to display the OSD menu.
2. Press VOL+ or VOL- to highlight TV.
20