Presetting Am/Fm Stations - Sangean RCR-28 User Manual

Radio operation-Manual tuning AM/FM
1. Fully extend the FM wire antenna located on the rear of your clock radio. Place the
wire antenna so that it is as straight as possible extending either above or below the
radio.
2. Press the Standby button to turn on your radio.
3. Press the Source button repeatedly to select AM (MW) or FM 1 or 2 frequency band.
4. Press the Tuning up/down button to change the frequency.
5. To see the time or frequency on the screen, press the Display button
Note:
When your radio has any interference in AM band by its adaptor, please move your
radio away from its AC adaptor over 30 cm.
Scan tuning AM/FM
1. Fully extend the FM wire antenna located on the rear of your clock radio. Place the
wire antenna so that it is as straight as possible extending either above or below the
radio.
2. Press the Standby button to turn on your radio.
3. Press the Source button repeatedly to select AM (MW) or FM 1 or 2 frequency band.
4. Press and hold the Tuning up/down button. Your radio will scan in an upwards direction
(low frequency to high frequency) or downwards direction (high frequency to low
frequency) and stop automatically when it finds a station with sufficient signal strength.

Presetting AM/FM stations

1. Press the Standby button to turn on your radio.
2. Press the Source button repeatedly to select AM (MW) or FM 1 or 2 frequency band.
3. Tune into the station that you would like to preset following the steps above.
4. Press and hold one of preset buttons until the radio beeps, the station frequency will
be saved into the chosen preset.
5. Repeat the procedure for the remaining presets. Your radio has 5 presets for each
frequency band.
6. The presets can be overwritten by following the above steps.
GB
7