Table of Contents
Advertisement
8.0 TUNING TV
Step 1.
TV SIGNAL SOURCE SELECTION
To select the desired signal source by remote control (Selecting what you want to watch i.e. TV,
• • • •
DVD, Video etc)
Press the "VIDEO" button until you enter TV mode
• • • •
Step 2.
CHANNEL NUMBER SELECTION
• • • •
You must first select channel number 1 on the remote before tuning in the television. If
Channel 1 is not selected, the auto tuning will not begin at channel 1.
• • • •
Auto tuning will begin at the channel you are on; all previous channels will be blank.
Step 3.
TV COLOUR SYSTEM SELECTION
You must first configure the Colour & Sound System (see below for details) before you can tune
your television. If you do not select the PAL Colour system and B/G Sound system, when you
tune your TV the picture will most likely be in black and white and the sound may be distorted
To select the "PAL" Colour system by remote control
• • • •
Press the "Menu" button to enter the Main menu
• • • •
Press the "VOL+" or "VOL-" button to navigate across
• • • •
the menu bar until you get to 'GENERAL SETTINGS'
Press "CH+" or "CH-" button to scroll up or down the
• • • •
drop down menu to select 'COLOUR SYSTEM'
Press "VOL+" or VOL-" button to select 'PAL' colour
• • • •
mode
Press the "Menu" button once to return to the main
• • • •
menu & again to exit the main menu
IMPORTANT:
IMPORTANT NOTE:
11
.
Advertisement
Table of Contents
