Log Placement - White Mountain Hearth ROCK CREEK LSU24RR-2 Installation Instructions And Owner's Manua

Before you begin: Do not, handle these logs with your bare hands! Always wear gloves to prevent skin irritation. After handling logs,
wash your hands gently with soap and water.
All Logs
The positioning of the logs is critical to the safe and clean operation of this heater. Sooting and other problems may result if the logs are
not properly and firmly positioned in the appliance.
refer to Figures 1 for the following warning.
warning: Failure to position the parts in accordance with this diagram or failure to use only parts specifically approved with this
appliance may result in property damage or personal injury.
PrOPer INSTALLATION SeQueNce:
ATTENTION: For the instructions below, "Front" indicates the
side of the burner with the air shutter to the right.
1. Facing the burner assembly with the pilot and air shutter to
the right, place Back Right Log (log A) onto right back pins
of burner.
2. Place Right Middle Log (log B) onto right middle pins of
burner.
3. Place Left Back Log (log C) onto left back pins of burner.
There is a bracket to support this log.
4. Place Left Middle Log (log D) onto left middle pins of
burner.
5. Place Right Front Log (log E) onto right front pin of burner.
There is a bracket to support this log.
6. Place Center Middle Log (log F) onto burner top against logs B
and D. This log rests on top of the center log support plate.
I
H
K
Attention: Do not use Figures 1 or 2 to order replacement logs. Refer to Page 7, Parts List and Parts View to order logs for your
appropriate model number.
Page 4

LOG PLACEMENT

L
Figure 1
7. Place Left Front Log (log G) onto left front pins of burner.
Note: There is a bracket to support this log.
8. Insert boss of Middle Bottom Branch (log H) into recess on
logs E, B, and C.
9. Insert boss of Middle Top Branch (log I) into recess on log H
(Middle Bottom Branch) and logs A and B.
10. Insert boss of Top Left Branch (log K) into recess on logs C,
D, and G.
11. Insert recess of Top Right Branch (log L) into the recess on
log A.
12. Compare the completed log installation with Figure 3. Review
previous steps to make any necessary adjustments.
13. Log placement is complete.
NOTe: When placed correctly, the logs will not cover any ports.
K
A
C
F
D
G
Log Placement
LSu24rr-2 Logs
I
L
H
B
Figure 2
24818-1-0209
E