Setting Up Broadcast Network Name - ActionTec SBWD100B User Manual

3. Click the Apply button, and then click OK on the pop-up message box to confirm.
4. The receiver reboots, and the new SSID takes effect after the reboot.

5.3.17. Setting up Broadcast Network Name

Follow the procedure below to set up Broadcast Network Name:
1. Go to the Local Management tab page by clicking the Local Management tab.
2. To enable/disable the Broadcast Network Name feature, go to the Wireless Local
Management Interface Settings section, and set the Broadcast Network Name
feature to Enable/Disable.
Note: By default, the receiver's network name (SSID) is not broadcasted. In this situation you
can connect to the SSID manually. Refer to Section 5.1.2. When SSID Broadcast is
Disabled for detail.
3. Click the Apply button, and then click OK on the pop-up message box to confirm.