Registration roller assembly
1.
Before proceeding, remove the following components:
Rear cover assembly. See
●
Left cover. See
●
2.
Unhook the clasp on the registration roller assembly gear (callout 1), and then slide the gear off of
the shaft.
Figure 1-125
3.
Open the cartridge door, and then remove four screws.
Figure 1-126
86
Chapter 1 Removal and replacement
Rear cover assembly on page
Left cover on page
28.
Remove the registration roller assembly (1 of 3)
1
Remove the registration roller assembly (2 of 3)
24.
ENWW