Fuser Motor - HP LaserJet PRO M521 Repair Manua

Fuser motor

WARNING!
1. Before proceeding, remove the following:
Formatter cover. See
●
Dummy cover. See
●
Formatter PCA. See
●
Rear cover assembly. See
●
Left cover. See
●
Right-rear cover. See
●
Tray 1 cover. See
●
Cartridge-door assembly. See
●
Right cover assembly. See
●
Lower right cover. See
●
Document feeder/scanner assembly. See
●
Top cover. See
●
DC controller. See
●
Low-voltage power supply. See
●
2.
Disconnect one connector (callout 1), remove three screws (callout 2), and then remove the fuser
motor.
Figure 1-179
120 Chapter 1 Removal and replacement
ESD sensitive component.
Formatter cover on page
Dummy cover on page
Formatter PCA on page
Rear cover assembly on page
Left cover on page
Right-rear cover on page
Tray 1 cover on page
Cartridge-door assembly on page
Right cover assembly on page
Lower right cover on page
Top cover on page
DC controller on page
Low-voltage power supply (LVPS) on page
Remove the fuser motor
1
18.
23.
19.
24.
28.
30.
32.
36.
41.
Document feeder/scanner assembly on page
95.
102.
2
34.
46.
106.
ENWW