Tray 1 Or Tray 2 Pickup Solenoid - HP LaserJet PRO M521 Repair Manua

Tray 1 or Tray 2 pickup solenoid

1.
Before proceeding, remove the following:
Formatter cover. See
●
Dummy cover. See
●
Formatter PCA. See
●
Rear cover assembly. See
●
Left cover. See
●
Right-rear cover. See
●
Tray 1 cover. See
●
Cartridge-door assembly. See
●
Right cover assembly. See
●
Lower right cover. See
●
Document feeder/scanner assembly. See
●
Top cover. See
●
DC controller. See
●
Low-voltage power supply. See
●
2. Carefully unwind the wire harness (callout 1) from the retainer on the gear cover (callout 2).
Reinstallation tip
wire harness around the retainer one and one-half times in a clockwise direction.
Figure 1-176
118 Chapter 1 Removal and replacement
Formatter cover on page
Dummy cover on page
Formatter PCA on page
Rear cover assembly on page
Left cover on page
Right-rear cover on page
Tray 1 cover on page
Right cover assembly on page
Lower right cover on page
Top cover on page
DC controller on page
When you reinstall the gear cover, make sure that you wrap the solenoid-
Remove the Tray 1 or Tray 2 pickup solenoid (1 of 3)
1
18.
23.
19.
28.
30.
32.
Cartridge-door assembly on page
41.
Document feeder/scanner assembly on page
95.
102.
Low-voltage power supply (LVPS) on page
2
24.
34.
36.
106.
46.
ENWW