JVC RX-8010VBK Service Manual page 7

Removing the main board
Prior to performing the following procedure, remove
the top cover, the rear panel and audio board.
1. Cut off the tie band fixing the harness.
2. Disconnect the harness from connector CN811 on
the power supply board respectively.
3. Disconnect the harness from connector CN881 on
the main board.
4. Remove the four screws I and the two screws J
attaching the main board.
Removing the Heat sink
1. Remove the ten screws K and four screws L
attaching the heat sink.
2. Remove the two screws L' attaching the heat sink
from the rear side of main board.
(See Fig.14)
(See Fig.15 to 16)
I
J
J
I
Main
board
CN881
Fig.14
K
Heat sink
L
L'
Main board
rear side
RX-8010VBK
I
J
CN811
Tie band
I
K
K
L
Fig.15
L'
Fig.16
1-7