JVC RX-8010VBK Service Manual page 5

Removing each board connected to the
rear side of the audio board
Prior to performing the following procedure, remove
the top cover and the rear panel.
1. Cut off the tie band fixing the harness.
2. Disconnect the connect CN501, CN243, CN205,
CN381, CN361 on the DVD board.
3. Disconnect the harness from connector CN721,
CN722 and CN723.
4. Disconnect the tuner board and audio board from
connector CN101 and CN301 on the audio board.
5. Pull out the video audio board, video board, S-video
board.
6. Disconnect the DSP board from connector CN601 on
the audio board.
Audio
board
CN416
CN303
CN201
CN241
Video audio
board
(See Fig.5 to 11)
CN206
CN244
S Video
Video
board
board
Fig.9
CN361
CN381
CN205
CN243
Fig.5
CN721
CN723
CN731
CN732
Fig.6
Fig.7
Tuner
board
CN101
RX-8010VBK
Tie band
CN501
CN722
DVD board
Audio input
board
CN301
Fig.8
1-5