Receiving - Global Water G3 Operation Manual

Receiving the Cooler
Unpacking
Global Water products are shipped completely assembled and
ready to operate. Remove the top of the box and slide the water cooler
out and save the box and packing materials.
Inspection
Inspect the cooler for shipping damage. Look at the exterior panels
to see if they have been dented or damaged. Check the dispensing
spigots in the front. Open the bottom panel to assure that the filter
system is in tact. Look at the back of the cooler to see if the compressor
is secure and has not broken from the mounting. Inspect the filter
system to see that nothing is damaged or dislodged from shipping.
Description (Model G3 and G4)
The Models G3 and G4 both provide water at two temperatures.
The water is dispensed from two spigots—one "hot" and one "cold." The
assembly drawing is shown in Figure 1 for the G3 and Figure 2 for the
G4. Water flows from the filter system into the top tank, also known as
the cold water tank. This tank then feeds the hot tank that is heated by
internal heaters. The level in the cold water tank is controlled by a float
valve mechanism. This mechanism controls a solenoid valve on the
water feed line to maintain a constant level of filtered water. Both
models are available with reverse osmosis (RO) or standard filter (F)
versions.
The water production flow chart is shown in Figure 3.
4 | P a g e