Table of Contents
Advertisement
8. Turn the ignition switch to the OFF position. Immediately observe the LED flash
pattern. You will notice the LED flashing five times, pause, and then flash two times,
pause. This pattern will be repeated three times indicating the new code (52) has
been accepted and stored in memory.
NOTE:
If after step 7, the LED flashes a code other than what was just entered, this
indicates that the code has not been changed. You will have to repeat steps 1
through 7 above being certain to note the following:
Acceptable digits 10ths or units are 1 through 9. The unit will not recognize a 0 (Zero),
or no digit entered in any place, units or tenths.
NOTE:
If 15 seconds of inactivity expire, or if the ignition switch is turned off for more
then 5 seconds during any of the above steps, the unit will revert back to the
last successfully stored code.
MANUALLY OVERRIDING YOUR SYSTEM:
USING THE CUSTOM CODE OVERRIDE
Assuming the override code programmed has not been changed and the default override
code of 11 is in the system's memory.
1) Enter the vehicle and turn the ignition switch to the on position.
NOTE: The siren will sound.
2) Within 5 seconds, press and release the Receivers push button switch 1 time.
3) Within 5 seconds, turn the ignition switch off then on.
4) Within 5 seconds, press and release the Receivers push button switch 1 time.
5) Turn the ignition switch off then on and start the vehicle.
NOTE:
If you have changed the programmed override code then substitute your new
code tenths for step 2 above, and units for step 5 above.
ELIMINATING THE NORMAL ARM/DISARM CHIRPS
You can selectively eliminate the normal arm and disarm chirps by holding the transmitter
button slightly longer when arming or disarming. This will prevent the siren chirps for
one arm or disarm cycle. If you find this inconvenient and wish to eliminate these chirps
permanently,
1. Turn the ignition switch 'on" then 'off".
2. Within 10 seconds of turning off the ignition, press and release the Receivers push
button switch 3 times.
3. If the chirps were on before you started, the siren will emit 2 short chirps indicating
that the chirps are now off. If the chirps were off before you started, the siren will emit
one short chirp indicating that the chirps are now on.
NOTE:
If the vehicle battery is disconnected then reconnected, the unit will return to
the default setting of chirps on. Repeat the above procedure to eliminate the
arm/disarm chirps.
REMOTE PANIC OPERATION
The Lock or Unlock button on your keychain transmitter also functions as a panic switch
for use in emergency situations.
Page 8
128-9305
8 of 16
Hide quick links:
Advertisement
Table of Contents
