Advertisement
ASSEMBLY
Assembly requires two persons. Place all parts of the exercise cycle in a cleared area and remove the pack-
ing materials. Do not dispose of the packing materials until assembly is completed.
In addition to the included tool(s), assembly requires an adjustable wrench
screwdriver
Note: If a part is not in the hardware kit, check to see if it has been preattached.
1. Remove the two screws (not shown), the two
washers (not shown), and the shipping bracket
(not shown) from the rear of the Frame (1).
Discard the screws, washers, and shipping
bracket.
Identify the Rear Stabilizer (7), which does not
have wheels.
Tighten two Leveling Feet (16) and two M10
Hex Nuts (49) into the underside of the Rear
Stabilizer (7).
Attach the Rear Stabilizer (7) to the Frame (1)
with two M10 x 25mm Screws (34) and two
M10 Washers (33).
2. Remove the two screws (not shown), the two
washers (not shown), and the shipping bracket
(not shown) from the front of the Frame (1).
Discard the screws, washers, and shipping
bracket.
Orient the Front Stabilizer (8) as shown.
Attach the Front Stabilizer (8) to the Frame (1)
with two M10 x 25mm Screws (34) and two
M10 Washers (33).
.
1
34
33
1
7
49
16
2
5
and a Phillips
49
16
34
33
34
33
1
8
21
21
Advertisement
