Sirius XM RAdio Starmate 8 User Manual page 16

Vehicle Installation
3. Attach the Vent Mount to the
PowerConnect Vehicle Dock using the 4
provided screws . If you plan to use the
wire guide channel across the back of
the Vehicle Dock to organize the wires,
do not fully tighten the screws . If not,
tighten the screws .
Note! For greater clarity, the next
illustration does not show the dock attached to the Vent Mount, however, the dock
should be attached before continuing .
4. Once the cables have been attached to the dock, push the Vent Mount onto
the vehicle vent as shown (1) until it hooks on the rear of the vent louver (2) .
5. Rest the foot against the bottom of the vent (2), and adjust the tilt of the Vent
Mount by repositioning the foot to the other adjustment hole (3) .
PUSH
TIP! To remove the Vent Mount, push the mount into the vent . Then lift up until
disengaged from the rear of the vent louver, and remove the Vent Mount .
16
1
Dash
Vent
FOOT
Louver
2
Dash
HOOKED
Vent
TILT
ADJUSTMENT
HOLES
3
Dash
Vent