Cleaning And Maintenance - Goddess RCB 2143GS7 Instruction Manual

ENG
● Function for Adjust Temperature Mode: In this mode you can adjust the setting
temperature freely for fridge and freezer room. To activate this function you can press
the Standard button for over 5 seconds continuously and the temperature of fridge
and freezer room will flicker on the LCD screen. Then depress the Standard button again,
the setting temperature will circulate within a range on the LCD screen. Each time you
press the Standard button, the setting temperature will increase one degree. If you have
selected the setting temperature and do not depress the Standard button within 8 seconds,
the control system will save your command and the unit will quit Adjust Temperature mode
and operate according to your selected setting temperature.
If you selected the temperature like this: for fridge room: +5 C; for freezer room: -18 C
the unit will work in Standard mode and the LCD screen will display STANDARD.
If the power supply is failed during your adjusting the setting temperature, when the power
resumes, the lasting setting will be accepted as default for operation.
Notes:
1. When the fridge door is open or when you operate the button on control panel, the LCD
screen back will be lighted in colour. It will last 10 minutes after you close the door or stop
depressing button. After 10 minutes the back light will go out.
2. Door open alarm: If the fridge room door is not closed for 30 seconds, the buzzer will beep 3
sounds every 30 seconds to remind you of closing the door. If the door is not closed well
after 10 ten minutes, the buzzer will stop beeping
3. When the power supply cord is connected to the power source, the refrigerator will dely 3
seconds to start in order to keep the power stable.
4. The control system has the function of 3 minutes delay to restart the machine to protect the
compressor.
5. When E1, E2 and E3 or their combinations etc diagnose codes are displayed in LCD
screen, even if the temperature in compartment is enough cold, you should ask your
local service centre to repair it.
1. When cleaning the refrigerator , disconnect the electric wire . Rub it carefully with a piece
of cloth soaked with neutral cleanser , then wipe it clean with fresh Water. Do not wash the
refrigerator with water directly to prevent the unit from rust and breakdown.
2. Never use acids , chemical solution , thinner , gasoline or the likes to clean the refrigerator
because they may damage the painting cover and plastic parts of it
ENG - 16

Cleaning and Maintenance: